During the construction of cable bridge, the construction staff must wear safety helmet when entering the site. In case of high-altitude operation, the scaffold shall be set up in advance and the safety belt shall be tied to the firm place. In addition to bearing the dead weight and cable load, the cable tray and bracket shall not bear other additional loads. It is not allowed to use the cable tray and bracket as the metal frame for supporting and fixing other devices or lifting objects.

電纜橋架

Cable tray

安裝時不能將橋架當作腳手架使用，并避免施工職員在橋架上攀登或站立工作。橋架嚴禁作為職員通道嚴禁在橋架上休息玩鬧。立柱焊接應牢固防止承載后跌落。橋架堆放應整潔留有可供職員行走的通道，在電纜夾層內進行橋架施工時，熱控橋架及保護管安裝照明光線應充足。

During installation, the bridge should not be used as scaffold, and the construction staff should not climb or stand on the bridge. The bridge is not allowed to be used as a passageway for staff. It is strictly forbidden to rest and play on the bridge. The column shall be welded firmly to prevent falling after bearing. The bridge should be stacked neatly, leaving a passage for staff to walk. When the bridge construction is carried out in the cable interlayer, the lighting for the installation of thermal control bridge and protection pipe should be sufficient.

嚴禁在土建構筑物上擅自打洞如確實施工需要必需按有關細則的劃定進行工作。施工中如遇垂直交叉功課必需有可靠隔離措施，否則必需避開。橋架在工作過程中嚴禁相互打鬧、拋擲各種物品，遇有違章或行為應立刻指出并制止。

It is strictly forbidden to drill holes on civil structures without authorization. If construction needs to be carried out, the work must be carried out according to the relevant rules. In case of vertical crossing in construction, reliable isolation measures must be taken, otherwise, it must be avoided. It is strictly forbidden to fight with each other and throw all kinds of articles during the working process of bridge. In case of any violation or behavior, it shall be pointed out and stopped immediately.

橋架使用的工具及設備材料應擺放整潔，嚴禁占用通道施工過程中應采取相應的防護措施。施工結束后，應清理好現場做到“工完、料盡、場地清”。焊接時焊條頭不得亂丟同一回收處理。施工中產生的邊角廢物由工地同一回收處理。施工照明不得有“長明燈”現象盡量減少電的消耗。這樣就達到了電纜橋架安全施工及環境保護措施。

The tools, equipment and materials used in the bridge should be placed neatly, and it is forbidden to occupy the passage. Corresponding protective measures should be taken during the construction. After the completion of construction, the site shall be cleaned up to achieve the goal of "completion of construction, material exhaustion and site cleaning". During welding, the welding rod head shall not be discarded and recycled. The corner waste generated during construction shall be recovered and treated by the same site. Construction lighting shall not have the phenomenon of "permanent lighting" to reduce the power consumption as far as possible. In this way, the safety construction and environmental protection measures of cable bridge are achieved.

以上就是對電纜橋架施工時確定鋼管位置的方法介紹，以及安裝方法，相信通過本文的描述，你能有所收獲，希望以上內容能對你有所幫助。

The above is the cable tray construction to determine the location of the steel pipe introduction, and installation methods, I believe that through the description of this article, you can get something, I hope the above content can help you.